Controlled-products-systems-group 790919 Manual de usuario Pagina 1

November, 2003 455 D Control Panel Installation Instructions CONTENTS General Description 2 Installing the 455 D Control Panel 2 Connect the

Page 10 November, 2003 455 D Control Panel Installation Instructions • When gate operator (1) reaches the position that you want it to slow down, an

Page 11 November, 2003 455 D Control Panel Installation Instructions COMPLETE LEARNING NOTES: • If only one gate operator (1) is used, you must

Page 12 November, 2003 455 D Control Panel Installation Instructions A (Automatic) Logic (455 D) Gate Status Open A Open B Stop Opening Reversing

Page 13 November, 2003 455 D Control Panel Installation Instructions E (Semi-automatic) Logic (455 D) Gate Status Open A Open B Stop Opening Reve

SAFETY IN GATE DESIGN • A gate is a potential traffic hazard, so it is important that you locate the gate far enough away from the road to eliminate

Page 15 November, 2003 455 D Control Panel Installation Instructions This page is left blank intentionally.

Page 16 November, 2003 455 D Control Panel Installation Instructions To the original purchaser only: FAAC International, Inc., warrants, for twenty-fo

THE 455 D CONTROL PANEL GENERAL DESCRIPTION The FAAC 455 D control panel is used to operate the following models. Swing gate operators: 400 412

RADIO1-455D115 = 115V1-455D = 230VF2F1MMK+OP -CL+24 VFS WNC -B -STOPA + TXFS WW. L.LOCK9 10 11 12 13 14 15 16 17 18 1922 23 24 25LA MPCOMOP CLMOTOR 1M

Page November, 2003 455 D Control Panel Installation Instructions You cannot check the motor’s direction of rotation without these circuits (jumpers)

Page 5 November, 2003 455 D Control Panel Installation Instructions normally open (N.O.) contacts. Connect such devices to terminals 9 and 14. NOTE:

• E (semi-automatic): This mode requires a command to open and a command to close. A second command during opening stops the gate. A second command

Magnetic LockShadow LoopRev ersing Photocells(f or closing)3 & 4 Wire Radio Receiv ersN.C.N.O.COMN.C.N.O.COM1714182112 vacRelay+-Lock121978NCCCoil

Page 8 November, 2003 455 D Control Panel Installation Instructions PROGRAMMING To program the automated system, the “Programming Mode” must be access

Page 9 November, 2003 455 D Control Panel Installation Instructions ADVANCED PROGRAMMING + Display Function Default MAXIMUM TORQUE AT INITIAL THRU