Controlled-products-systems-group SK-1323-SDQ Manual de usuario descargar pdf (Pagina 10)

ENFORCER Outdoor Stand-Alone Keypads

SECO-LARM U.S.A., Inc 11

6. Exit Programming Mode by pressing again.

4. Exit Programming Mode by pressing .

Programming Output #1

E. Setting the Output #1 Access Mode*

DEFAULT: User card OR user code.

2. Enter .

1. Enter Programming Mode by entering the Master Code twice.

User card ONLY

Either user card OR user code (DEFAULT)

3. Enter one of the following:

User card AND user code

1. Enter a user ID number.

Each Output #1 user can be programmed to have a user code and a user card.*

A. User Code Only

4. To program the next user, repeat from step 1 in section A, B, or C.

5. Exit Programming Mode by pressing .

2. If the left LED is red, previous user data exists. Clear it by entering . The keypad will beep in

confirmation and the left LED will turn green.

3. Enter a new user code.

( to )

Note – For all of the following programming functions, the keypad must be in Programming Mode. To enter

Programming Mode, enter the Master Code twice.

Note: Deleting all users is recommended before changing the access mode to user card with user

code. See page 14, Deleting All Users.

*SK-2323-SPQ and SK-1323-SPQ only.

D. Program the Master Card (SK-1323-SPQ and SK-2323-SPQ only)

In addition to a Master Code, a Master Card can also be programmed. Swiping a Master Card will give

direct access to Programming Mode.

1. Enter Programming Mode by entering the Master Code twice. (Default Master Code is 1234)

3. On the keypad, enter .

4. Swipe a proximity card (PR-K1S1A or similar). This card is now the Master Card.

5. Exit Programming Mode by pressing .

2. If the left LED is solid green and the right LED is flashing orange, a Master card is already

programmed. Clear it by entering . The keypad will beep in confirmation and the left LED

will start flashing green.

1. Enter a user ID number.

4. Return to Programming Mode by pressing .

3. Swipe a new user card.

5. To program the next user, repeat from step 1 in section A, B, or C.

B. User Card Only*

2. If the left LED is red, previous user data exists. Clear it by entering . The keypad will beep in

confirmation and the left LED will turn green.

( to )

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Comentarios a estos manuales

Sin comentarios

Controlled-products-systems-group SK-1323-SDQ Manual de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Panel De Control Controlled-products-systems-group SK-1323-SDQ