Controlled-products-systems-group E-9643-4B190Q Manual de usuario descargar pdf (Pagina 10)

ENFORCER Long-Range Barrier Sensors

SECO-LARM U.S.A., Inc.

Aligning the Beams

1. To align the beams, loosen the swivel screw and adjust the beams to face each other.

Connect the power to the receiver and transmitter. If the beams are not aligned, the red

LED on the receiver will light ON (see Fig. 13).

2. For audible confirmation in addition to the LED, make sure jumper JP1 is plugged in on

the receiver’s circuit board. If the beams are not aligned, the receiver’s buzzer will

sound. To disable this feature, remove JP1 (see Fig. 14).

3. Once the beams are aligned, the red LED will turn off and the buzzer will not sound.

Programming the Trigger Mode

1. The default detection method is when any 2 adjacent pair of beams is broken, or when

any single pair of beams are broken more than 2 seconds (see Fig.19).

2. The latter (any single pair of beams broken) detection function can be disabled when

the JP2 jumper is removed.

Fig. 13 – Aligning the beams

Fig. 14 – Jumper position (JP1)

Alignment buzzer

OFF

Alignment buzzer

Fig. 15 – Programming buzzer ON/OFF

(JP1) and detection mode (JP2).

Fig. 16 – Jumper position (JP2)

Detection mode

OFF

Detection mode

1 2 ... 5 6 7 8 9 10 11 12

Sin comentarios

Controlled-products-systems-group E-9643-4B190Q Manual de usuario Pagina 10