Controlled-products-systems-group 8550C-7 Manual de usuario descargar pdf (Pagina 12)

Fiberglass,aluminum or lightweight steel garage doors WILLREQUIRE reinforcement BEFORE

installation of door bracket. Contactyour door manufacturer for reinforcement kit.

Figure 1 showsone piece ofangle iron as the horizontal brace.

For the vertical brace, 2 pieces ofangle iron are used to create a

U-shaped support. The best solution is to check with your garage

door manufacturer for an opener installation door reinforcement

kit.

NOTE: Many door reinforcement kits provide for direct attachment

of the clevis pin and door arm. In this case you will not need the

door bracket; proceed to the next step.

Self-Threading Screw

1/4"-14x5/8"

HARDWARE

SECTIONALDOORS

8.1 Center the door bracketon the previously marked vertical centerline used for the header bracket

installation.Note correct UP placement, asstamped inside the bracket.

8.2 Position the top edge of the bracket 2"-4" (5-10 cm) below the top edge of the door,OR directlybelow

any structural supportacross the top of the door.

8.3 Mark, drill holes and install as follows, depending on your door’s construction:

Metal orlight weight doors usinga verticalangle iron brace betweenthe door panelsupport

andthe door bracket:

• Drill 3/16" fastening holes.Secure the door bracketusing the two selfthreading screws.

(Figure 2)

• Alternately,use two 5/16" bolts, lock washers and nuts (not provided). (Figure 3)

Metal, insulated orlight weight factory reinforced doors:

• Drill 3/16" fastening holes.Secure the door bracketusing the self-threading screws. (Figure 4)

WoodDoors:

• Use top and bottom or side to side door bracketholes.Drill 5/16” holes through the door and

secure bracketwith 5/16"-18x2" carriage bolts, lock washersand nuts(notprovided). (Figure 5)

NOTE: The 1/4"-14x5/8" self-threading screws are not intended for use on wood doors.

8 Install the door bracket

A horizontal and vertical reinforcement

is needed for lightweight garage doors

(ﬁ berglass, aluminum, steel, doors

with glass panel, etc.) (not provided).

A horizontal reinforcement brace

should be long enough to be secured

to two or three vertical supports.

A vertical reinforcement brace should

cover the height of the top panel.

FIGURE 1

FIGURE 2

FIGURE 4

FIGURE 5

FIGURE 3

Vertical Reinforcement

Vertical Centerline

of Garage Door

Door Bracket

Self-Threading Screw

1/4" - 14x 5/8"

Self-Threading

Screw

1/4" - 14x 5/8"

Vertical Reinforcement

Bolt 5/16"-18x2"

(Not provided)

Lock Washer 5/16"

Nut 5/16"-18

Door Bracket

Vertical Centerline

of Garage Door

Vertical

Centerline of

Garage Door

Bolt 5/16"-18x2"

(Not provided)

Inside Edge of Door or

Reinforcement Board

Vertical Centerline

of Garage Door

Installation

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 81 82

Comentarios a estos manuales

Sin comentarios

Controlled-products-systems-group 8550C-7 Manual de usuario Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Controlled-products-systems-group 8550C-7