Controlled-products-systems-group 8550C-7 Manual de usuario descargar pdf (Pagina 23)

Withouta properly installed safety reversal

system, persons (particularlysmall children)

could be SERIOUSLY INJURED or KILLED bya

closing garage door.

• Incorrectadjustmentof garage door travel

limits will interfere with proper operation of

safetyreversal system.

• After ANY adjustmentsare made, the safety

reversal systemMUST be tested. Door

MUST reverse on contact with 1-1/2" (3.8

cm) high object (or 2x4 laid flat) on floor.

To preventdamage to vehicles,be sure fully

open door provides adequate clearance.

INTRODUCTION

Your garage door opener is designed with

electronic controls to make setup and

adjustments easy.The adjustments allow you

to program where the door will stop in the

open (UP) and close (DOWN) position.The

electronic controls sense the amount offorce

required to open and close the door. The

force is adjusted automatically when you

program the travel.

NOTE: If anything interferes with the door’s

upward travel it will stop. If anything interferes

with the door’s downward travel, it will reverse.

To watch a short instructional video on

programming your newgarage door opener

use your smartphone to read the QR Code

below:

PROGRAMMING BUTTONS

The programming buttons are located on the

leftside panel ofthe garage door opener and

are used to program the travel.

UP (Open)

DOWN (Close)

UP Button

Adjustment

Button

DOWN Button

PROGRAMMING BUTTONS

Adjustments

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 81 82

Sin comentarios

Controlled-products-systems-group 8550C-7 Manual de usuario Pagina 23