Controlled-products-systems-group 8550C-7 Manual de usuario descargar pdf (Pagina 33)

3 Using a safetypin or paper clip,press the

program button until the LEDs on the frontof

the remote control turn on.

4 Pressand release the Learn button on the

garage door opener.The Learn LEDwill light.

Within 30 seconds...

5 Pressand release the remote control button you want to use...

Check to see if the garage door opener lightbulb blinks.Ifnot, wait for the remote control LEDto

lightsolid then slowly pressand release the remote control button again.

Repeat until the lightbulb blinks.DONOTpress the button after the lightbulb blinks.

6 To exitprogramming mode,pressany remote control button except the button that was just

programmed.

7 To test, pressthe programmed button on the remote control... The garage door opener will

activate.

To Erase the Memory

ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES

1 Pressand hold the learn button on garage door opener until the learn LEDgoesout

(approximately 6 seconds). All remote control and keyless entry codes are now erased.

Reprogram any accessoryyou wish to use.

ERASE ALL DEVICES (Including MyQ

enabled accessories)

1 Pressand hold the learn button on garage door opener until the learn LEDgoesout

(approximately 6 seconds).

2 Immediately pressand hold the learn button again until the learn LED goesout.All codesare

now erased.

Reprogram any accessoryyou wish to use.

Remote Control

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 81 82

Sin comentarios

Controlled-products-systems-group 8550C-7 Manual de usuario Pagina 33