Controlled-products-systems-group 8550C-7 Manual de usuario descargar pdf (Pagina 24)

1 Program the

Travel

Withouta properly installed safety reversal system, persons (particularlysmall children) could be SERIOUSLY INJUREDor KILLED bya closing garage door.

• Incorrectadjustmentof garage door travel limitswill interfere with proper operation of safety reversal system.

• After ANY adjustmentsare made, the safetyreversal system MUST be tested.Door MUST reverse on contactwith 1-1/2" (3.8 cm) high object(or 2x4 laid flat) on

floor.

1.1 Press and hold the

AdjustmentButton until

the UP Button begins to

flash and/or a beep is

heard.

1.2 Press and hold the UP Button until the door is in

the desired UP position.

NOTE: The UPand DOWNButtons can be

used to move the door up and down as needed.

1.3 Once the door is in the desired UP position

press and release the Adjustment Button. The

garage door opener lights will flash twice and

the DOWN Button will begin to flash.

1.4 Press and hold the DOWN Button until the door

is in the desired DOWN position.

NOTE: The UPand DOWNButtons can be

used to move the door up and down as needed.

1.5 Once the door is in the

desired DOWN position

press and release the

AdjustmentButton. The

garage door opener

lights will flash twice

and the UP Button will

begin to flash.

1.6 Press and release the UP Button.When the

door travels to the programmed UP position, the

DOWN Button will begin to flash.

1.7 Press and release the DOWN Button. The door

will travel to the programmed DOWN position.

Programming is complete.

If the garage door opener lights are flashing 5 times

during the steps for Program the Travel,the

programming has timed out. Ifthe garage door opener

lights are flashing 10 timesduring the steps for

Program the Travel,the safetyreversing sensorsare

misaligned or obstructed (refer to page 22).When the

sensorsare aligned and unobstructed, cycle the door

through a complete up and down cycle using the

remote control or the UP and DOWN buttons.

Programming is complete.Ifyou are unable to operate

the door up and down, repeat the steps for

Programming the Travel.

Adjustments

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 81 82

Comentarios a estos manuales

Sin comentarios

Controlled-products-systems-group 8550C-7 Manual de usuario Pagina 24

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Controlled-products-systems-group 8550C-7