Controlled-products-systems-group SLIDESMART DC 10F Manual de usuario descargar pdf (Pagina 25)

Site Overview & Planning

Revision D Installation 1-3

Using an Existing Pad

In many applications, SlideSmart may be a replacement

operator for an existing gate system.

Make sure the pad is level and inspect the pad for:

• Compliance with local building codes.

• Appropriate distance from the gate. See Figure 1-4.

• Appropriate dimensions (See Figure 1-2) for

SlideSmart installation.

• Durability.

To use an existing pad, take the following steps:

1. Remove any existing equipment from the pad.

2. Measure the pad to ensure it is sized properly for

SlideSmart.

3. Check the mounting hole locations and re-drill, if

necessary.

4. Follow the steps in

Concrete Pad Mount

CAUTION

Consider positioning the operator so existing conduit enters the cutout in the SlideSmart base

plate. Cutting small holes in the plastic base plate and cover for pre-existing conduit is

permissible. Two 0.875-inch (22mm) diameter holes for running conduit are also provided on

both sides of the chassis. See Figure 1-5.

Side View

¾"

(19.7cm)

Figure 1-4.

Concrete pad

Chain

Chain to Gate

Ideal distance =

Minimum distance = 2½" (6.4cm)

height

Grade

level

Gate

3¾" (9.5cm)

Cut out

if rear

install

Figure 1-5.

Conduit cut outs

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 147 148

Comentarios a estos manuales

Sin comentarios

Controlled-products-systems-group SLIDESMART DC 10F Manual de usuario Pagina 25

Comentarios a estos manuales

Relacionado con productos y manuales para La Seguridad Controlled-products-systems-group SLIDESMART DC 10F