Controlled-products-systems-group SLIDESMART DC 10F Manual de usuario descargar pdf (Pagina 36)

Gate Bracket and Chain Installation

1-14 SlideSmart Installation and Reference Manual Revision D

8. To verify that the operator recognizes the target magnet, turn off both DC and AC power switches and

watch the display go blank. Then, turn both switches on. The operator beeps indicating Limit Relearn

Mode. The gate then travels about 6 inches (15cm) in the open direction and stops. The buzzer beeps

again and the gate travels in the close direction at a rate of ½ ft/s until the target magnet passes the target

sensor. The buzzer sounds one last time, the operator resets, and “GATE CLOSED” appears on the

display.

9. If “LEARN OPEN” appears, then the target magnet was not detected. Check chain alignment and make

sure the target magnet passes across the face of the sensor. See Figure 1-18. Repeat steps 6 - 8. If you are

still having difficulty with the operator learning its limits, re-install the target magnet. See Establishing

the OPEN & CLOSE Limits on page 1-12.

RONT

NSTALLATION

Figure 1-19.

CAUTION

When the gate is CLOSED, the target magnet should stop between the idler wheel and

the roller chain sprocket. The target magnet MUST NOT enter the sprocket teeth. See

Figure 1-19.

PUBLICPUBLIC

SECURESECURE

Roller chain sprocket

Idler wheel

Target

(LH gate)

sensor

Position of the target

magnet when the gate is

fully closed.

Second target

sensor is not used

Trailing edge of gate

(Gate shown in full

CLOSE position)

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 147 148

Sin comentarios

Controlled-products-systems-group SLIDESMART DC 10F Manual de usuario Pagina 36